Navajo 2WD V6-4.0L OHV (1992)
Windshield: Customer Interest
Windshield - Molding Partially Dislodged From the Glass
Bulletin No.
029/92
Issued
5/6/92
Revised
Category
S
Applicable Model/s
1991 - '92
Navajo
Subject:
LOOSE WINDSHIELD MOLDING
DESCRIPTION
The windshield molding may become partially dislodged from the glass. This condition occurs primarily along the top of the windshield and is caused
by inadequate retention of the molding.
AFFECTED VEHICLES
All applicable models.
INSPECTION & REPAIR PROCEDURE
To secure the windshield molding assembly to the glass, use the following procedure.
1.
Press the windshield molding assembly back onto the glass.
2.
Lift the molding where shown in Figure 1.
NOTE:
Lifting the molding too much will cause molding to buckle.
3.
Fill the area beneath the molding with a small bead of clear RTV silicone scaler (1/8 inch bead). Figure 1.
NOTE: