Navajo 4WD V6-4.0L OHV (1991)
Crankshaft Position Sensor: Service and Repair
Variable Reluctance Sensor (VRS)
1.
Disconnect negative battery cable.
2.
Disconnect sensor electrical connector.
3.
Remove sensor mounting screws and remove sensor.
4.
Position new sensor assembly on engine and install mounting screws. Tighten to 75 - 106 inlb (8.5 - 12 Nm).
5.
Ensure that sensor wiring harness is properly routed and plug connector into sensor.
6.
Reconnect negative battery cable.