Protege L4-1839cc 1.8L DOHC (1990)
3. Install the camshaft pulley lock bolts.
4. Hold the camshaft with a wrench.
5. Tighten the camshaft pulley lock bolt.
Tightening torque:
50-60 N.m (5.0-6.2 kgf.m, 37-44 ft.lbf).
Inspection
Camshaft
1. Set the front and rear journals on V-blocks.
2. Measure the camshaft runout. Replace the camshaft if necessary.
Runout: 0.03mm (0.0012 in) max.
3. Inspect the camshaft for wear or damage. Replace the camshaft if necessary.
4. Measure the cam lobe heights at the two points as shown.
Height
Standard
IN: 44.094mm 11.7360 in)
EX: 44.600mm 11.7560 in)
Minimum
IN: 43.894mm 11.7281 in)
EX: 44.4ODmm 11.7480 in)