Protege DX L4-2.0L DOHC (2002)
15. Use a brush to apply primer to the bonding area of the glass and body within the region shown.
CAUTION: Keep the area free of dirt and grease, and do not touch the surface, otherwise the primer may not properly bond to the surface of the
glass and body, which may cause leaks to occur.
NOTE: Use only glass primer on the glass, and body primer on the body and molding. Allow it to dry for approximately 30 minutes.
16. Once the primer is dry, apply sealant measuring 11.0 mm {0.433 in} in height and 5.0 mm {0.20 in} in width around the entire circumference to
fill the gap between the dam and the edge of the glass.
17. Align the marks on the glass with the V-notches in the spacers and install the glass onto the body.
18. Press firmly inward on the glass to compress the sealant.
Hardening Time Of Sealant
19. Verify that the gap along the upper and side edge is 8.8 mm {0.35 in}.
20. Install the headliner.