Tribute 2WD L4-2.3L (2005)
2. Trim the remaining urethane adhesive on the pinch weld to within specification. The surface should be smooth and free of cuts and contamination.
3. Use the wool applicator to apply metal primer to any exposed metal on the pinch weld. Allow six to ten minutes to dry.
4. If reinstalling the original windshield, remove excess urethane adhesive from the windshield glass.
5. Clean the inside of the glass surface with an alcohol-free cleaner making sure the ceramic-coated area is clean.
CAUTION: Wipe off urethane glass prep immediately after each application because it flash dries.
6. If installing a new windshield, apply glass prep twice around the glass surface.
7. If installing a new windshield, apply glass primer to the same area that was propped in the previous step. Allow five minutes to dry.
8. Apply foam dam to the bottom of the windshield glass.
9. Cut the urethane applicator tip to specification.
10. Apply a bead of urethane adhesive to the sides and top of the windshield glass.