Tribute 2WD L4-2.5L (2009)
3. If equipped with a manual transmission, release the clamp and disconnect the clutch hose from the brake fluid reservoir.
-
Plug the clutch master cylinder feed hose.
4. Disconnect the 2 brake tube fittings and plug the brake tubes and the brake master cylinder ports.
-
To install, tighten to 23 Nm {2.3 kgf-m, 17 ft-lbf}.
5. Remove and discard the 2 master cylinder nuts.
-
To install, tighten new nuts to 25 Nm {2.5 kgf-m, 18 ft-lbf}.
NOTE:Install new master cylinder nuts.
6. Remove the brake master cylinder assembly.
7. To install, reverse the removal procedure.
-
Bleed the master cylinder. See See: Brake Bleeding/Service and Repair/Brake System Bleeding.
-
If equipped with a manual transaxle, bleed the clutch master cylinder. See See: Transmission and Drivetrain/Clutch/Clutch Hydraulic
System/Service and Repair.