Tribute 2WD L4-2.5L (2009)
10. Detach the all wiring harness pin-type retainer from the intake manifold and position the wiring harness aside.
11. Remove the intake manifold lower bolt.
-
To install, tighten to 18 Nm {1.8 kgf-m, 159 in-lbf}.
12. Remove the 6 bolts and position the intake manifold aside to access the crankcase vent oil separator tube and the EGR tube.
-
To install, tighten to 18 Nm {1.8 kgf-m, 159 in-lbf}.
13. Squeeze the 2 crankcase vent oil separator tube tabs and disconnect the tube from the intake manifold.
14. Remove the EGR tube.
-
Tighten to 55 Nm {5.6 kgf-m, 41 ft-lbf}.
15. Remove the intake manifold and gaskets.
16. To install, reverse the removal procedure.
-
Inspect and install new intake manifold gaskets if necessary.