Tribute 2WD L4-2.5L (2009)
5. Remove the condenser inlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm {1.5 kgf-m, 133 in-lbf}.
6. Remove the A/C compressor discharge fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm {1.5 kgf-m, 133 in-lbf}.
7. Remove the compressor-to-condenser discharge line.
8. To install, reverse the removal procedure.
-
Install new gasket seals and O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil. See See: Service and Repair/Refrigerant Oil Adding.
9. Evacuate, leak test and charge the refrigerant system. See See: Service and Repair/Air Conditioning (A/C) System Evacuation And Charging.