Tribute 2WD L4-2.5L (2009)
Canister Purge Control Valve: Service and Repair
EVAPORATIVE EMISSIONS CANISTER PURGE VALVE REMOVAL/INSTALLATION
CAUTION:Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly
flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
CAUTION:Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious
personal injury.
CAUTION:Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or fuel-related
component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
1. Disconnect the battery ground cable.
2. Disconnect the Evaporative Emission (EVAP) canister purge valve electrical connector.
3. Disconnect the 2 fuel vapor tube-to-EVAP canister purge valve quick connect couplings. See - See: Fuel Delivery and Air Induction/Fuel Line
Coupler/Service and Repair/Quick Release Coupling - Double Locking.
4. Remove the 2 bolts and the EVAP canister purge valve.
-
To install, tighten to 6 Nm {0.6 kgf-m, 52 in-lbf}.
5. To install, reverse the removal procedure.
-
Carry out the evaporative emission system leak test. See See: Testing and Inspection/Component Tests and General Diagnostics.