Tribute 4WD L4-2.5L Hybrid (2009)
3. If equipped with a manual transmission, release the clamp and disconnect the clutch hose from the brake fluid reservoir.
-
Plug the clutch master cylinder feed hose.
4. Remove the reservoir.
-
Release the retaining clips on the underside of the reservoir.
-
Pull the reservoir upwards.
5. Remove and discard the 2 seals.
6. To install, reverse the removal procedure.
-
Install new seals. Lubricate the seals with clean, specified brake fluid.
-
Bleed the brake system. See See: Brake Bleeding/Service and Repair/Brake System Bleeding.
-
If equipped with a manual transaxle, bleed the clutch master cylinder. See .