Tribute 4WD L4-2.5L Hybrid (2009)
Wheel Cylinder: Removal and Replacement
WHEEL CYLINDER REMOVAL/INSTALLATION
WARNING:Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been
previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal
injury.
WARNING:Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. For
additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious
personal injury.
CAUTION:Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic
surface, immediately wash it with water.
1. Remove the rear brake shoes. See See: Drum Brake System/Brake Shoe/Service and Repair.
2. Disconnect the brake tube fitting.
-
To install, tighten to 18 Nm {1.8 kgf-m, 159 in-lbf}.
3. Remove the 2 wheel cylinder bolts and remove the wheel cylinder.
-
To install, tighten to 11 Nm {1.1 kgf-m, 97 in-lbf}.
4. To install, reverse the removal procedure.
-
Bleed the wheel cylinder. See See: Brake Bleeding/Service and Repair/Component Bleeding.
