Tribute DX 4WD V6-3.0L DOHC (2002)
NOTE: The driver seat installation is shown, the passenger seat installation is similar.
WARNING: Inspect the mounting surfaces of the side air bag module and the seat back frame mounting bracket for any foreign objects before
installing the side air bag module. If any foreign objects are found, remove them. Failure to do so may result in personal injury, in the event of
an air bag deployment.
WARNING: Before installing the side air bag module, check it for damage and foreign objects. If the air bag module is damaged, replace
it. If any foreign objects are found, remove them. Failure to do so may result in personal injury, in the event of an air bag deployment.
WARNING: If the air bag cover has separated or the air bag material has been exposed, install a new side air bag module. Do not attempt to
repair the air bag module. Failure to do so may result in personal injury in the event of an air bag deployment.
CAUTION: Make sure the side air bag wiring harness is not pinched between the side air bag module and the mounting bracket.
1. Install the side air bag module onto the seat backrest frame mounting bracket.
1. Position the side air bag module to the seat backrest frame mounting bracket.
2. Install the nuts.
2. Route the side air bag wire harness and install the pin-type retainers to the seat backrest frame.
WARNING: Inspect the side air bag cavity in the seat back pad for any foreign objects. If any foreign objects are found, remove them.
Failure to do so may result in personal injury in the event of an air bag deployment.
3. Position the seat backrest pad onto the seat backrest frame.
