Tribute LX 2WD V6-3.0L DOHC (2001)
Transmission Speed Sensor: Service and Repair
Output Shaft Speed (OSS) Sensor
Removal
1. Raise and support the vehicle.
2. Remove the LH front wheel.
3. Remove the splash shield.
4. Remove the output shaft speed (OSS) sensor.
1
Disconnect the OSS sensor electrical connector.
2
Remove the bolt.
3
Inspect the OSS bore.
5. Inspect the O-ring seal for nicks or cuts. Install a new seal as necessary.
Installation
Note: Apply a light coat of petroleum jelly to the O-ring before installation.
