Sable V6-183 3.0L DOHC VIN S MFI (1997)
5. Install attachment parts in proper sequence. Original parts are to be replaced with the service parts indicated.
Seat Belt Without Anchor Plate Thread Damage
The lap/shoulder safety belts are factory-installed in their proper locations. If the belts are removed for any reason, they should be installed as described
in Removal and Installation. The 7/16 x 20 Torx head anchor bolts must be hand-started and tightened to 34-46 Nm (25-33 lb ft).
1. Remove the damaged bolt for the anchor reinforcement and discard.
2. Install a new bolt. Original parts are to be replaced with the service parts indicated.
Shoulder Safety Belt Height Adjuster With Stripped Weld Nuts
1. With the B-pillar interior trim panel removed, drill out the damaged threads in the upper B-pillar structure using a 1/2 inch drill.
NOTE: If the two hex-head attaching bolts on the shoulder safety belt height adjuster are not stripped, install the shoulder safety belt height
adjuster to the body structure as described in Removal and Installation. If the front seat shoulder strap adjuster attaching bolts are stripped, replace
the shoulder safety belt height adjuster and install it to the body structure as described in Removal and Installation.
