Sable V6-183 3.0L DOHC VIN S MFI (1997)
8. On RH side inboard CV joint stub shaft pilot bearing housing, install a new circlip, supplied with service kit, in groove nearest end of shaft by
starting one end in groove and working circlip over stub shaft end and into groove.
CAUTION: Do not over-expand or twist circlip during installation. DO NOT reuse circlips. Replace with new circlips before assembly.
9. Work the CV joint through its full range of travel at various angles. The joint should flex, extend and compress smoothly.
Outboard
DISASSEMBLY
NOTE:
^
The front wheel driveshaft joint components are matched during manufacture and therefore cannot be interchanged with components from another
front wheel driveshaft joint. Extreme care should be taken not to mix or substitute like components between front wheel driveshaft joints.
^
Vise jaw caps are made of copper, brass wood or other soft material. They are slipped over the steel jaws of the vise so as not to scratch or nick
finished surfaces.
