Sable V6-183 3.0L DOHC VIN S MFI (1997)
1. Clamp front wheel driveshaft joint in a vise. Do not allow vise jaws to contact the front wheel driveshaft joint boot or its front wheel driveshaft
joint boot clamp.
NOTE: The vise should be equipped with jaw caps to prevent damage to any machined surfaces.
Boot Clamp Removal
Boot Removal
2. Cut the front wheel driveshaft joint boot clamps using side cutters and pull away from the front wheel driveshaft joint boot. After removing the
front wheel driveshaft joint boot clamp, slide front wheel driveshaft joint boot down over shaft.
3. Support interconnecting shaft in a soft jaw vise and angle the CV joint to expose the inner bearing race.
