Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Seat Track: Service and Repair
Roller Assembly
REMOVAL
1. Remove the center seat(s) from the vehicle.
2. Remove the rear bench seat.
3. Remove the front seat and front seat support assemblies.
4. Remove the interior trim:
a. LH quarter trim panel
b. RH quarter trim panel
c. Liftgate opening scuff plate
d. Rear door scuff plate
e. RH center body pillar inside lower finish panel
5. Roll up the floor carpet into the front seating area to expose the rear seat tracks.
6. Remove the stopper bolts from the front of each rear seat track.
7. Release each seat track roller assembly by pressing the roller release and sliding the roller assembly forward off the rear seat track.
INSTALLATION
1. Slide each roller onto the front end of the rear seat track.
2. Install the stopper bolts in each rear seat track.
3. Install the floor carpet.
4. Install the interior trim:
a. LH quarter trim panel
b. RH quarter trim panel
c. Liftgate opening scuff plate
d. Rear door scuff plate
e. RH center body pillar inside lower finish panel
5. Install the front seat and front seat support assemblies.
6. Install the rear bench seat.
7. Install the center seat(s) if necessary.