Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
13. Use a prybar and separate the front stabilizer bar link from the front suspension lower arm.
14. Separate the front wheel driveshaft and joint from the wheel hub.
15. Position drain pans under the transaxle.
16. If removing the LH front wheel driveshaft and joint, position prybars on both sides of the outer race, between the outer race and the transaxle case.
Gently pry outward to unseat the circlip.
CAUTION: Extreme care must be used to ensure that the prybar does not damage the transaxle case, differential oil seal, outer race or boot.
17. After removing the LH front wheel driveshaft joint, pry the circlip off of the front wheel driveshaft joint. Discard the circlip.
18. Remove the three front axle bearing retainer-to-bracket bolts.