Workshop Manuals Factory service & repair Mini
01 Introduction02 General information03 Information04 Engine05 Emission control06 Engine management system - MEMS07 Fuel delivery system08 Cooling system09 Manifold & exhaust systems10 Clutch11 Manual gearbox12 Drive shafts13 Steering14 Suspension15 Brakes16 Restraint systems17 Body18 Heating & ventilation19 Wipers & washers20 Electrical21 Instruments
Mini Mini Workshop Manual (1996-2000)03 · Information
03 · General

Manual gearbox models

Make
Mini
Model
Mini Workshop Manual
Year
1996–2000
Section
Lifting and towing › Manual gearbox models
InformationManual gearbox models

Manual gearbox models

Use the front lashing/towing eye (1) for towing the car on all four wheels from the front.

WARNING: To ensure that the steering does not lock when the car is being towed, it is essential that the starter key is turned to position ’I’, and remains there while the car is moving. Ensure the following precautions are observed: Do not tow if the gearbox or a drive shaft is faulty. Do not tow if a wheel or drive shafts are touching the body or frame. Ensure the gear lever is in neutral and the handbrake is released. Remember that greater effort than normal will be necessary to apply the brakes if the car is being towed without the engine running.

Automatic gearbox models

When a car with an automatic gearbox is to be towed, a suspended tow must be used because the gearbox is not adequately lubricated without the engine running. The following precautions must be observed:

The selector must be at ’N’.

CAUTION: A rear suspended tow must not be attempted as serious damage will be caused to the automatic transmission.

NOTE: A vehicle fitted with an automatic gearbox cannot be started by towing or pushing.

Parts & tools for this job For 1996 Mini Mini

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.