mini Workshop Repair Guides

Mini Workshop Service and Repair Manuals

Replacing Power Steering Intake Pipe|Page 11035 > < Replacing Power Steering Intake Pipe
Page 2
background image

Install hint:

Bleed power steering.

ECVT Automatic Transmission

Caution:  Make sure all parts are absolutely clean. Seal off pipe connections with plugs. No dirt is allowed to enter the system.

Recycling:

Observe country-specific waste-disposal regulations.

Draw hydraulic fluid out of tank - do not reuse.

Install hint:

Fill hydraulic system.

Caution:  Pull high voltage connector straight or damage may occur.

Release clip from intake pipe (1) on supply tank and release pipe.

Disconnect connector (1).

Disconnect high voltage connector (2).

Remove screw (1) and disconnect pressure pipe.

 
High pressure pipe to power pack

M8 x 1.25 x 20 Screw .......................................................................................................................................................................................  10 Nm

Replacing Power Steering Intake Pipe|Page 11035 > < Replacing Power Steering Intake Pipe