3000GT V6-3.0L SOHC (1998)
If the measured value is not within the standard range, first adjust the rack support cover, and then check the total pinion starting torque again.
If the total pinion starting torque cannot be adjusted to within the standard range by adjusting the rack support cover, check the rack support cover,
rack support spring, rack support and replace any parts necessary.
Check The Tie Rod For Swing Resistance
1. Give 10 hard swings to the tie rod.
2. Measure the tie rod swing resistance with a spring scale.
Standard value: 8 - 18 N (1.8 - 4.0 lbs.)
Torque: 2 - 5 Nm (17 - 43 inch lbs.)
3. When the measured value exceeds the standard value, replace the tie rod assembly.
4. When the measured value is lower than the standard value, check that the ball joint swings smoothly without excessive play. If so, it is possible
to use that ball joint.
Tie Rod End Ball Joint Dust Cover Check
1. Check the dust cover for cracks or damage by pushing it with finger.
2. If a dust cover is cracked or damaged, replace the tie rod end.
NOTE: Cracks or damage of the dust cover may cause damage of the ball joint. When it is damaged during service work, replace the dust
cover.
