3000GT V6-3.0L SOHC (1998)
Remove the mounting bolts which hold the speed sensor bracket to the knuckle, and then remove the speed sensor.
CAUTION: Be careful when handling the pole piece at the tip of the speed sensor and the toothed edge of the rotor so as not to damage them by
striking against other parts.
<B> Drive Shaft Nut Removal
Loosen the drive shaft nut while the vehicle is on the floor with the brakes applied.
CAUTION: Do not apply vehicle load to the wheel bearing loosing the drive shaft nut. If, however, vehicle load must be applied to the bearing in
moving the vehicle, temporarily secure the wheel bearing by using the special tools, MB990998, etc.
<C> Caliper Assembly Removal
Remove the caliper assembly and suspend it with wires.
<D> Lower Arm Ball Joint Disconnection
Using the special tool, disconnect the lower arm ball joint from the knuckle.
CAUTION:
1. Be sure to tie the cord of the special tool to the nearby part.
2. Loosen the nut but do not remove it.
<E> Tie Rod End Disconnection
