3000GT VR-4 AWD V6-2972cc 3.0L DOHC MFI Twin Turbo (1998)
1. Attach the special tools to the knuckle and front hub.
2. Secure the knuckle in a vise.
3. Tighten the nut of the special tool and remove the hub and rotor from the knuckle.
CAUTION:
1. Be sure to use the special tools.
2. If the hub and knuckle are disassembled by striking them with a hammer, the bearing will be damaged.
<B> Wheel Bearing Removal
1. Crush the oil seal in two places to that the tabs of the special tool will be caught on the wheel bearing inner race.
2. Remove the wheel bearing inner race from the hub by using the special tool.
CAUTION: Be careful that the hub will not fall down as the wheel bearing inner race (outer side) is removed from the hub.
3. Remove the snap ring from the knuckle.
4. Remove the bearing by using the special tools.
NOTE: Removal is easier if the outer side inner race removed from the hub is placed on the bearing and the wheel bearing is then removed.
