Eclipse L4-2.4L (4G69) (2008)
Q: Is door switch (RH) connector D-01 in good condition?
YES : Go to Step 8.
NO : Repair or replace the damaged component(s). Refer to General (Electrical), Harness Connector Inspection. If the functions described in
"CIRCUIT OPERATION" work normally, the input signal from the door switch (RH) should be normal.
STEP 8. Check the door switch (RH).
Remove the door switch (RH). Refer to Body, Door, Door Assembly. Then check continuity between the switch terminals and the body ground.
Q: Is the door switch (RH) in good condition?
YES : Go to Step 9.
NO : Replace the door switch (RH). If the functions described in "CIRCUIT OPERATION" work normally, the input signal from the door switch
(RH) should be normal.
STEP 9. Measure resistance at the lower metal part of the door switch (RH) in order to check the ground circuit to the door switch (RH).
NOTE: Check that the door switch (RH) is grounded to the vehicle body via its mounting screw.