Eclipse L4-2.4L (4G69) (2008)
Q: Is ETACS-ECU connector C-217 in good condition?
YES : Go to Step 7.
NO : Repair or replace the damaged component(s). Refer to general (electrical), Harness Connector Inspection. If the rear wiper operates
normally, it indicates that a correct auto-stop signal is sent from the rear wiper motor.
STEP 7. Check the wiring harness between rear wiper motor connector F-03 (terminal 3) and ETACS-ECU connector C-217 (terminal 17).
NOTE: Also check intermediate connector F-02 and junction block connector C-208 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If intermediate connector F-02 or junction block connector C-208 are damaged, Repair or replace the damaged component(s) as
described in general (electrical), Harness Connector Inspection.
Q: Is the wiring harness between rear wiper motor connector F-03 (terminal 3) and ETACS-ECU connector C-217 (terminal 17) in good condition?
YES : Replace the ETACS-ECU. When the ETACS-ECU is replaced, register the encrypted code. Refer to chassis electrical, Encrypted Code
Registration Criteria Table. If the rear wiper operates normally, it indicates that a correct auto-stop signal is sent from the rear wiper motor.