Eclipse V6-3.8L (6G75) (2006)
-
The ETACS-ECU may be defective
-
The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
DIAGNOSIS
Required Special Tool:
-
MB991223: Test Harness Set
-
MB992006: Extra Fine Probe
STEP 1. Check rear wiper motor connector F-03 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is rear wiper motor connector F-03 in good condition?
YES: Go to Step 2.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. If the rear wiper operates normally, it indicates that a
correct auto-stop signal is sent from the rear wiper motor.
STEP 2. Check the rear wiper.
Q: Does the rear wiper motor operate (however, the rear wiper does not stop at the predetermined park position)?
YES: Go to Step 3.
NO: Refer to Inspection Procedure H-1 "Rear wiper does not work at all."
STEP 3. Check the rear wiper motor.
1. Disconnect rear wiper motor connector F-03.