Eclipse V6-3.8L (6G75) (2006)
1. Disconnect SRS-ECU connector C-123.
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958.
2. Connect scan tool MB991958 to the data link connector.
3. Diagnose CAN bus lines, and check if scan tool MB991958 screen is as shown in the illustration.
Q: Does scan tool MB991958 screen correspond to the illustration?
YES: Repair the wiring harness between joint connector (3) and the SRS-ECU connector.
NO: Check the SRS-ECU connector, and repair if necessary. If the SRS-ECU connector is in good condition, replace the SRS-ECU.
STEP 11. Check the CAN line between intermediate connector C-24 and ABS-ECU <vehicles without traction control system> or
ABS/TCL-ECU <vehicles with traction control system> connector for a short to ground. Measure the resistance at intermediate connector