Eclipse V6-3.8L (6G75) (2006)
-
After operating the seat belt pre-tensioner, replace the seat belt pre-tensioner with a new part.
-
Gloves and protective goggles must be worn when handling a seat belt pre-tensioner once it has been used.
-
If disposing of a seat belt with pre-tensioner which has not yet been operated, its seat belt pre-tensioner must be operated first before disposal.
-
When removing and installing the front passenger seat, be sure to carry out accuracy check occupant classification sensor after the seat has been
installed in the vehicle. (On-vehicle Service)
Required Special Tools:
-
MB991958: Scan Tool (MUT-III Sub Assembly)
-
MB991824: V.C.I.
-
MB991827: USB Cable
-
MB991910: Main Harness A
REMOVAL SERVICE POINTS
[[A]] NEGATIVE (-) BATTERY CABLE DISCONNECTION
DANGER: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and seat belt pre-tensioner operation.
[[B]]PRE-TENSIONER CONNECTOR DISCONNECTION
1. Use a flat-tipped screwdriver to unlock the locking button of the harness-side connector by withdrawing it toward you in two stages.
2. Disconnect the pretensioner connector.
INSTALLATION SERVICE POINTS
]]A[[ PRE-INSTALLATION INSPECTION
WARNING: Dispose of seat belt pre-tensioner only according to the specified procedure.
1. When installing the new seat belt pre-tensioner, refer to "INSPECTION".
2. Connect the negative (-) battery cable.
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958.