Eclipse V6-3.8L (6G75) (2006)
Stabilizer Bar Removal Steps 12-16 & Required Special Tool
REMOVAL SERVICE POINTS
<<A>> STEERING GEAR AND STEERING COLUMN ASSEMBLY DISCONNECTION
1. Remove the steering gear and steering column assembly connecting bolt.
2. Pinch the steering column shaft clip with pliers, and pull up the shaft in the direction shown to disengage the steering column assembly.
NOTE: If the steering column shaft is removed accidentally remove the steering column assembly and be sure to insert the steering column
shaft into the steering column as shown in the Figure.
<<B>> TIE ROD END AND KNUCKLE DISCONNECTION
CAUTION:
^
Do not remove the nut from ball joint. Loosen it and use special tool MB991897 to avoid possible damage to ball joint threads.
^
Hang special tool MB991897 with a cord to prevent it from failing.