Eclipse V6-3.8L (6G75) (2006)
1. Install special tool MB991897 as shown in the figure.
2. Turn the bolt and knob as necessary to make the jaws of special tool MB991897 parallel, tighten the bolt by hand and confirm that the jaws are
still parallel.
NOTE: When adjusting the jaws in parallel, make sure the knob is in the position shown in the figure.
3. Tighten the bolt with a wrench to disconnect the tie rod end.
<<C>> FRONT AXLE CROSSMEMBER STAY REMOVAL
The crossmember mounting bolts should not be unscrewed when the front axle crossmember stay is replaced. However, the bolts may be loosened
while the front axle crossmember stay is removed. It is recommended that you retighten the bolts to 180 ± 20 Nm (133 ± 14 ft. lbs.).
INSTALLATION SERVICE POINTS
>>A<< STABILIZER BAR/STABILIZER BUSHING/STABILIZER BRACKET INSTALLATION
Align the stabilizer bar identification mark with the right end of the bushing (LH).
>>B<< CROSSMEMBER ASSEMBLY INSTALLATION