Eclipse GS L4-2350cc 2.4L SOHC MFI (2002)
STEP 6. Check the wiring harness between sunroof motor assembly connector D-06 and fusible link (2).
NOTE: Also check intermediate connectors C-31, C-89 and joint connector C-78. If intermediate connector C-31, C-89 and joint connector C-78 is
damaged, repair or replace the connector as described in Harness Connector Inspection.
Q: Is the wiring harness between sunroof motor assembly connector D-06 and fusible link (2) in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. The system should communicate with the sunroof motor assembly (sunroof-ECU) normally.
STEP 7. Check sunroof motor assembly connector D-06 by backprobing in order to the ignition switch (IG2) line of the power supply circuit to
the sunroof motor assembly.
1. Measure at sunroof motor assembly connector D-06 without disconnecting it.
2. Turn the ignition switch to the "ON" position.
3. Measure the voltage between terminal 2 and ground by backprobing.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 10.
NO: Go to Step 8.
STEP 8. Check sunroof motor assembly connector D-06 for damage.
Q: Is sunroof motor assembly connector D-06 in good condition?