Eclipse GS L4-2350cc 2.4L SOHC MFI (2002)
YES: Go to Step 9.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. The system should communicate with the sunroof motor assembly
(sunroof-ECU) normally.
STEP 9. Check the wiring harness between sunroof motor assembly connector D-06 and ignition switch (IG2).
NOTE: Also check junction block connectors C-102 and C-111. If junction block connector C-102 or C-111 is damaged, repair or replace the
connector as described in Harness Connector Inspection.
Q: Is the wiring harness between sunroof motor assembly connector D-06 and the ignition switch (IG2) in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. The system should communicate with the sunroof motor assembly (sunroof-ECU) normally.
STEP 10. Measure at sunroof motor assembly connector D-06 in order to check the ground circuit to the sunroof motor assembly.
1. Disconnect sunroof motor connector D-06, and measure at the wiring harness side.