Eclipse GS L4-2350cc 2.4L SOHC MFI (2002)
STEP 6. Check the harness wires between sunroof motor assembly connector D-06 and battery.
NOTE: After checking joint connector C-78 and intermediate connector C-31 and C-89, check the wires. If joint connector C-78 and intermediate
connector C-31 or C-89 are damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Are the harness wires between sunroof motor assembly connector D-06 and battery in good condition?
YES: No action to be taken.
NO: Repair or replace them. The sunroof should work normally.
STEP 7. Check the sunroof motor assembly power supply circuit [ignition switch (IG2)] at the sunroof motor assembly connector D-06 by
backprobing.
1. Do not disconnect the sunroof motor assembly connector D-06.
2. Turn the ignition switch to "ON" position.
3. Measure the voltage between terminal 2 and ground by backprobing.
-
The measured value should be approximately 12 volts (battery positive voltage).