Eclipse GT V6-3.0L SOHC (2000)
STEP 5. Check the multi-center display connector C-09 for damage.
If the multi-center display connector C-09 is damaged, repair or replace it. Refer to Harness Connector Inspection.
The multi-center display should work normally.
If the connector is in good condition, go to Step 6.
STEP 6. Check the harness wires between C-09 and battery.
NOTE: After checking joint connector C-78 and intermediate connector C-89, check the wires. If joint connector C-78 and intermediate connector C-89
are damaged, repair or replace them. Refer to Harness Connector Inspection.
If the harness wires between C-09 and battery are damaged, repair them.
The multi-center display should work normally.
STEP 7. Check the multi-center display power supply circuit [ignition switch (ACC)] at the multi-center display connector C-09.
1. Disconnect the multi-center display connector C-09 and measure at the harness side.
2. Turn the ignition switch to "ACC" position.
3. Voltage between terminal 3 and ground.
-
Voltage should be approximately 12 volts (battery positive voltage).