Eclipse GT V6-3.0L SOHC (2000)
If not approximately 12 volts, go to Step 8.
If approximately 12 volts, go to Step 10.
STEP 8. Check multi-center display connector C-09 for damage.
If multi-center display connector C-09 is damaged, repair or replace it. Refer to Harness Connector Inspection.
The multi-center display should work normally.
If the connector is in good condition, go to Step 9.
STEP 9. Check the harness wires between C-09 and ignition switch (ACC).
NOTE: After checking joint connector C-78 and junction block connector C-101 and C-104, check the wires. If joint connector C-78 and junction block
connector C-101 and C-104 are damaged, repair or replace them. Refer to Harness Connector Inspection.
If the harness wires between C-09 and ignition switch (ACC) are damaged, repair them.
The multi-center display should work normally.