Eclipse GT V6-3.0L SOHC (2000)
STEP 10. Check the multi-center display power supply circuit [ignition switch (IG1)] at the multi-center display connector C-09.
1. Disconnect the multi-center display connector C-09 and measure at the harness side.
2. Turn the ignition switch to "ON" position.
3. Voltage between terminal 2 and ground.
-
Voltage should be approximately 12 volts (battery positive voltage).
If not approximately 12 volts, go to Step 11.
If approximately 12 volts, replace the multi-center display. The multi-center display should work normally.
STEP 11. Check the multi-center display connector C-09 for damage.
If the multi-center display connector C-09 is damaged, repair or replace it. Refer to Harness Connector Inspection.
The multi-center display should work normally.
If the connector is in good condition, go to Step 12.