Eclipse GT V6-3.0L SOHC (2000)
STEP 1. Check the ETACS-ECU power supply circuit [fusible link (2)] at the ETACS-ECU connector C-114.
1. Disconnect the ETACS-ECU connector C-114 and measure at the junction block side.
2. Voltage between terminal 16 and ground.
-
Voltage should be approximately 12 volts (battery positive voltage).
If not approximately 12 volts, go to Step 2.
If approximately 12 volts, go to Step 4.
STEP 2. Check the junction block connector C-114 for damage.
If the junction block connector C-114 is damaged, repair or replace it. Refer to Harness Connector Inspection.
The central door locking system should work normally
If the connector is in good condition, go to Step 3.
