Eclipse GT V6-3.0L SOHC (2000)
-
Key reminder switch
-
Driver's and passenger's door switch
-
Driver's and passenger's door lock actuator switch
<When using scan tool MB991502>
CAUTION: To prevent damage to scan tool MB991502, always turn the ignition switch to "LOCK" (OFF) position before connecting or disconnecting
scan tool MB991502.
1. Connect scan tool MB991502 to the data link connector.
2. Check that the tone alarm of scan tool MB991502 sounds when the input signal enters.
<When using a voltmeter>
1. Use special tool MB991529 to connect a voltmeter between ground terminal 4 or 5 and ETACS-ECU terminal 9 of the data link connector.
2. Check that the voltmeter indicator deflects once when the input signal enters.
If one of the input signals checks shows a defect, check the relevant input circuit.
If no defect appears, replace the ETACS-ECU.
The forgotten key prevention function should work normally.
Inspection Procedure D-1
