mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2298 > < Initial Inspection and Diagnostic Overview|Page 2296
Page 85
background image

STEP 6. Check the harness wire between rear washer motor connector A-34 and ground.

If the harness wire between rear washer motor connector A-34 and ground is damaged, repair it.
The rear washer should work normally.

STEP 7. Check the rear washer motor connector A-34 and ETACS-ECU connector C-114 for damage.

If the rear washer motor connector A-34 and ETACS-ECU connector C-114 are damaged, repair or replace them. Refer to Harness Connector
Inspection. The rear washer should work normally.
If the connectors are in good condition, go to Step 8.

Initial Inspection and Diagnostic Overview|Page 2298 > < Initial Inspection and Diagnostic Overview|Page 2296