Eclipse GT V6-3.0L SOHC (2000)
STEP 3. Check the harness wires between ETACS-ECU connector C-114 and ignition switch (IG1).
NOTE: After checking junction block connector C-101, check the wires. If junction block connector C-101 is damaged, repair or replace it. Refer to
Harness Connector Inspection.
If the harness wires between ETACS-ECU connector C-114 and ignition switch (IG1) is damaged, repair them. The ignition switch (IG1) input signal
should be able to be
checked and the functions, which are described in the "Technical Description (comment)," should work normally.
Inspection Procedure O-3