Eclipse Spyder GT V6-3.0L SOHC (2002)
STEP 18. Check the position light bulb (RH).
1. Remove the position light bulb (RH).
2. Check that the position light bulb (RH) is not broken.
Q: Is the position light bulb (RH) in good condition?
YES: Go to Step 19.
NO: Replace the position light bulb (RH). Check that the position light (RH) illuminates normally.
STEP 19. Measure at position light (RH) connector A-32 in order to check the ground circuit to the position light (RH).
1. Disconnect position light (RH) connector A-32, and measure at the wiring harness side.
2. Measure the resistance value between terminal 2 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 22.
NO: Go to Step 20.
STEP 20. Check position light (RH) connector A-32 for damage.
Q: Is position light (RH) connector A-32 in good condition?
YES: Go to Step 21.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the position light (RH) illuminates normally.
