Eclipse Spyder GT V6-3.0L SOHC (2002)
STEP 3. Check the theft-alarm horn relay.
Q: Is the theft-alarm horn relay normal?
YES: Go to Step 4.
NO: Replace the theft-alarm horn relay. All the vehicle horn (including the theft-alarm horn) should sound when the theft-alarm system is triggered.
STEP 4. Measure at theft-alarm horn relay connector A-06X in order to check the fusible link (4) line of the power supply system to the
theft-alarm horn relay.
1. Disconnect theft-alarm horn relay connector A-06X, and measure at the relay box side.
2. Measure the voltage between terminal numbers 1, 2 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 7.
NO: Go to Step 5.
STEP 5. Check theft-alarm horn relay connector A-06X for damage.
Q: Is theft-alarm horn relay connector A-06X in good condition?
YES: Go to Step 6.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. All the vehicle horn (including the theft-alarm horn) should sound when
the theft-alarm system is triggered.
