Endeavor V6-3.8L SOHC (2004)
PARKING BRAKE LINING AND DRUM
REMOVAL AND INSTALLATION
REMOVAL SERVICE POINTS
<<A>> REAR BRAKE BOLT/REAR BRAKE CALIPER ASSEMBLY REMOVAL
Remove the rear brake caliper assembly and support it with wire or something similar.
<<B>> REAR BRAKE DISC REMOVAL
If the rear brake disc is seized, install M8x1.25 bolts as shown, and remove the rear brake disc by tightening the bolts evenly and gradually.
<<C>> REAR BRAKE CHAMBER RETAINER REMOVAL
Use a flat-tipped screwdriver or a similar tool to open up the rear brake chamber retainer joint. Then remove the rear brake chamber retainer.
INSTALLATION SERVICE POINTS
>>A<< REAR BRAKE CHAMBER RETAINER INSTALLATION
Use pliers or a similar tool to close the rear brake chamber retainer end onto the pin.
