Lancer L4-2.0L (4B11) (2008)
Cruise Control Switch: Testing and Inspection
Auto-Cruise Control Switch Check
AUTO-CRUISE CONTROL SYSTEM COMPONENT CHECK
AUTO-CRUISE CONTROL SWITCH CHECK
1. Remove the auto-cruise control switch (Refer to Engine and Emission Control).
2. Measure the resistance between terminal 2 and terminal 3 when each of the "ON/OFF" (MAIN), "CANCEL", "COAST/SET" and "ACC/RES"
switches is pressed. If the values measured at the time each switch is pressed correspond to those in the table below, the resistance values are
correct.