Lancer L4-2.0L (4B11) (2008)
1. Use a 6.0 / diameter / mm drill to make a hole in the flange of rivet as shown.
2. Break the rivet, and remove the rivet and heat protector.
INSTALLATION SERVICE POINTS
>>A<< FRONT FLOOR FRONT PANEL HEAT PROTECTOR/FRONT FLOOR REAR PANEL HEAT PROTECTOR/RIVET
INSTALLATION
Use a riveter to tighten the rivet by the following procedure.
1. Insert part A of rivet into the riveter, and insert the rivet into the assembling area.
2. Operate the tool's handle while pushing the flange surface of rivet by riveter. Part A of rivet is cut and the rivet is tightened.
>>B<< OXYGEN SENSOR INSTALLATION
1. Tighten the oxygen sensor to the specified torque by using special tool MB991953.
Tightening torque: 44 ± 5 N.m (33 ± 3 ft.lb)
2. Connect the oxygen sensor connector and install the connector bracket.