Lancer L4-2.4L SOHC (2005)
NO: Replace the front power regulator assembly (RH). When the power window sub-switch (front: RH) is operated, the front power window (RH)
should open or close normally.
STEP 8. Check the battery power supply circuit to the power window sub-switch (front: RH). Measure the voltage at power window sub-switch
(front: RH) connector E-14.
1. Disconnect power window sub-switch (front: RH) connector E-14 and measure the voltage available at the wiring harness side of the connector.
2. Turn the ignition switch to the "ON" position. (3) Measure the voltage between terminal 6 and ground.
-
The voltage should equal approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 11.
NO: Go to Step 9.
STEP 9. Check power window relay connector C-224 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is power window relay connector C-224 in good condition?
YES: Go to Step 10.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection.