Lancer L4-2.4L SOHC (2005)
Inspection Procedure M-6
Column switch: ETACS-ECU does not receive any signal from windshield mist wiper switch, windshield intermittent wiper switch, windshield
low-speed wiper switch, windshield high-speed wiper switch, windshield washer switch.
Windshield Wiper And Washer Switch Input Circuit
CIRCUIT OPERATION
The ETACS-ECU operates the following equipment or functions according to signal from the column switch (windshield wiper and washer switch):
-
Windshield wiper and washer
TECHNICAL DESCRIPTION (COMMENT)
If the signal is not normal, the equipment, which is described in "CIRCUIT OPERATION", does not work normally.
TROUBLESHOOTING HINTS
-
The column switch (windshield wiper and washer switch) may be defective
-
The ETACS-ECU may be defective
-
The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
DIAGNOSIS
Required Special Tools:
-
MB991223: Harness Set
-
MB991958: Scan Tool (MUT-III Sub Assembly)
-
MB991824: Vehicle Communication Interface (V.C.I.)
-
MB991827: MUT-III USB Cable
-
MB991911: MUT-III Main Harness B
-
MB991813: SWS Monitor Kit
-
MB991806: SWS Monitor Cartridge
-
MB991812: SWS Monitor Harness (For Column-ECU)
-
MB991922: Probe Harness
STEP 1. Use scan tool MB991958 to select "ECU COMM CHK" on the SWS monitor display.
Check the column-ECU.
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958. Connect the DLC harness before connecting the column-ECU harness. Be sure to connect SWS monitor kit