Lancer L4-2.4L SOHC (2005)
Windshield Wiper Motor Drive Circuit
TECHNICAL DESCRIPTION (COMMENT)
This system may be at fail-safe mode as the SWS communication line is defective. If the system can not receive any signal from the column switch
(windshield wiper and washer switch) due to a open circuit in the SWS communication line or other reasons, the system will enter the fail-safe mode
when the ignition switch is at the "ACC" position.
TROUBLESHOOTING HINTS
-
The column switch may be defective (windshield wiper and washer switch)
-
The front-ECU may be defective
-
The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
DIAGNOSIS
Required Special Tools:
-
MB991223: Harness Set
-
MB991958: Scan Tool (MUT-III Sub Assembly)
-
MB991824: Vehicle Communication Interface (V.C.I.)
-
MB991827: MUT-III USB Cable
-
MB991911: MUT-III Main Harness B
-
MB991813: SWS monitor kit
Use scan tool MB991958 to select "ECU COMM CHK" on the SWS monitor display.
Check the following ECUs:
-
Column-ECU
-
Front-ECU
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958. Connect the DLC harness before connecting the column-ECU harness. Be sure to connect SWS monitor kit
MB991813 after turning on scan tool MB991958.