Lancer L4-2.4L SOHC (2005)
1. Connect scan tool MB991958 to the data link connector.
2. Connect SWS monitor kit MB991813 to the column switch connector.
3. Turn the ignition switch to the "ON" position.
4. Operate scan tool MB991958 according to the procedure below to display "ECU COMM CHK.
a. Select "SYSTEM SELECT.
b. Select "SWS.
c. Select "SWS MONITOR.
d. Select "ECU COMM CHK.
5. Scan tool MB991958 should show "OK" on the "ECU COMM CHK" menus for both the "COLUMN ECU" and the "FRONT ECU" menus.
Q: Are "OK" displayed on both the "COLUMN ECU" and "FRONT ECU" menus?
"OK" are displayed for all the items : Replace the front-ECU. Check that the windshield wiper works normally.
"NG" is displayed on the "COLUMN ECU" menu : Refer to Inspection Procedure A-2 "Communication with column switch (column-ECU) is
not possible."
"NG" is displayed on the "FRONT ECU" menu : Refer to Inspection procedure A-4 "Communication with front-ECU is not possible."
Inspection Procedure G-3
Windshield Wiper and Washer: Any of the windshield wiper switch positions is defective.