Lancer L4-2.4L SOHC (2005)
STEP 2. Check fog light (LH) connector A-29 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is fog light (LH) connector A-29 in good condition?
YES: Go to Step 3.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the fog lights illuminate normally.
STEP 3. Check the fog light bulb (LH).
1. Remove the fog light bulb (LH).
2. Verify that the fog light bulb (LH) is not damaged or burned out.
Q: Is the fog light bulb (LH) in good condition?
YES: Go to Step 4.
NO: Replace the fog light bulb (LH). Verify that the fog lights illuminate normally.
STEP 4. Check the ground circuit to the fog light (LH). Measure the resistance at fog light (LH) connector A-29.
1. Disconnect fog light (LH) connector A-29 and measure the resistance available at the wiring harness side of the connector.
2. Measure the resistance value between terminal 2 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?